TM-9-2520-272-40

TM 9-2520-272-40

0016

CAUTION

Do not tighten cover bolts unless right cover assembly is fully installed. Damage to right cover

assembly could result.

NOTE

As you lower the right cover, turn the output f ange left and right again and again to align

gear and shaft splines.

Use brake adjust adapter on left and right brake adjust shafts to turn shafts as necessary to

align splines at hidden ends of shafts.

It may be necessary to slightly turn right cover assembly while you lower it.

It may be necessary to use plastic-faced hammer to help install right cover on transmission.

When properly aligned, the right cover will drop nearer to the transmission. Cover may not

install completely until it is bolted.

6. Lower the right cover assembly (Figure 6, Item 1) while turning the output f ange (Figure 6, Item 18) using the

socket wrench socket on brake shafts (Figure 6, Item 17). Lower the right cover assembly (Figure 6, Item 1)

until it is installed over new gasket (Figure 6, Item 14).

7. Remove two bolts (Figure 6, Item 10), two washers (Figure 6, Item 11), and multiple-leg sling (Figure 6, Item

12) from the right cover assembly (Figure 6, Item 1).

8. Install right lifting bracket on right cover assembly. Refer to TM 9-2350-277-13&P for instructions.

9. Install 3/8-16 x 3-1/2 inch bolt (Figure 7, Item 8) and washer (Figure 7, Item 9) in the right cover assembly

(Figure 7, Item 1).

10.Install 26 3/8-16 x 1-1/4 inch bolts (Figure 7, Item 6) and 26 washers (Figure 7, Item 7) around the perimeter of

the right cover assembly (Figure 7, Item 1).

0016

‐

TM-9-2520-272-40 - Page 118 of 620