TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 116 of 620

TM 9-2520-272-40

0016

INSTALL RIGHT COVER ASSEMBLY

NOTE

Make sure the right brake adjusting cover has been removed. The brake adjusting cover

restricts access to right cover bolt when installing cover.

1. Install new right cover gasket (Figure 4, Item 14) on transmission (Figure 4, Item 16).

2. Install 3/8 inch f at washers (Figure 4, Item 11) on each of two 3/8-16 x 3-1/2 bolts (Figure 4, Item 10), and put

bolts through lugs of multiple-leg sling (Figure 4, Item 12).

NOTE

Bolts must not extend beyond the inside surface of the right cover. If tips of the bolts extend

beyond the surface of the right cover, the right cover will not install correctly on the new gasket.

3. Install two bolts (Figure 4, Item 10) in two threaded holes (Figure 4, Item 13) in right cover assembly (Figure

4, Item 1).