TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 162 of 779

Figure 4-165.

Para 4-17

Figs. 4-126 through 4-130

Para 4-18a Figs. 4-167, 4-168

Para 4-18

Para 4-18d

Para 4-18e

Figs. 4-166 through 4-168

Figs. 4-157 through 4-133, 4-130 through 4-126

Note.

Make certain adjusting screw pad is

positioned squarely on end of valve stem. Refer

to Section X, figures 4-188 and 4-189 for valve

adjustment.

Figure 4-164. Positioning valve adjusting

screw pad on end of valve stem.

Section

Vlll.

OVER

HAUL

OF

FUEL

INJECTOR

NOZZLE

AND

HOLDER ASSEMBL Y

4-16. General

Figure references are listed under appropriate

This section covers the overhaul of the fuel

headings in the table.

injector nozzle and holder assembly. Refer to

Note.

Table 4-7 provides illustrations for

Table 4-7 for illustrations and instructions on

removal and installation of all upper covers to

removal,

testing, disassembly, cleaning, in-

gain access to the fuel injector nozzle and holder

spection,

repair, assembly, and installation.

assemblies. It is not necessary to remove all

covers unless all assemblies are to be rebuilt.

Table 4-7. Fuel Injector Nozzle and Holder Assembly

4-80