TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 175 of 779

Note.

Draw flywheel to crankshaft by in-

stalling three transmission drive shaftgear and

flywheel bolts and alternately tighten about one

turn at a time to draw flywheel into dowel pins

without binding.

Remove bolts and install

transmission drive gearshaft following the above

procedure until both flywheel and transmission

drive gearshaft are properly alined on dowel

pins.

Figure 4-183. Installing flywheel, using bolts

to draw flywheel against crankshaft.

Section X. SERVICE OPERATIONS

4-21. General

of engine disassembly to perform. Refer to Table

This section covers

service operations

4-9 for illustrations and instructions on service

allocated to the Direct Support Maintenance

operations covered in this section. Figure and

Organization. Procedures outlined in this section

paragraph references will be listed under ap-

are for service operations requiring a minimum

propriate headings in the table.

4-93