TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 178 of 779

Remove

Install

1. Remove two nuts (A), bolts, one plate, and two

1. Position new gaskets on exhaust valve openings.

clamps attaching fuel tubes to support.

Install valve adjusting screw cover plates and supports

2. Remove two bolts (B) attaching support to valve

and install two bolts (B) securing supporta and covers

adjusting screw cover plate. Remove supports and cover

to cylinders.

plates. Remove and discard gaskets.

2. Install two clamps, one plate, two bolts, and nuts (A)

3. Remove two bolts (C) and flat washers attaching

securing fuel tubes to support.

each of the remaining valve adjusting screw cover plates

and remove the plates. Remove and discard gaskets.

Figure 4-186. Removing or installing valve adjusting screw cover

plates -right side.

4-96