TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 187 of 779

CHAPTER 5

DISASSEMBLY OF ENGINE

Section I. PREPARATION OF ENGINE FOR DISASSEMBLY

5-1. General

must be thoroughly drained, cleaned, and

This section covers the preparation of the

stripped o f

external

accessories before

engine for disassembly. Refer to the pertinent

proceeding with disassembly. Refer to Table 5-1

TM’s covering the removal of powerplant from

for illustrations and instructions required for

the vehicle and separation of the transmission

draining engine oil and removing accessories.

from the engine. Prior to disassembly, engines

Table 5-1. Draining Engine Oil and Removing Engine Accessories

Engine and Sling

Oil Pan Drain Plugs

Fuel Pump

Starter

Time Totalizing Meter

Generator and Associated Parts

Turbosupercharger and Lower Shroud Plates

5-1

5-2, 5-3

4-1 through 4-3

4-4 through 4-8

5-4, 5-5

4-11 through 4-16

4-20 through 4-33

5-2. Drain Engine Oil

The engine oil must be drained from the

engine before engine is disassembled. Lift engine

using multiple leg sling -4910-919-2884 (fig. 5-

1) and place engine on suitable blocks. Drain

engine oil following instructions that accompany

figures 5-2 and 5-3.

Figure 5-1. Lifting engine using multiple leg

sling-4910-919-2884.

5-1