TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 192 of 779

Remove

Figure 5-9. Oil filler and oil level indicator

tube shroud plate oil drain hose

grommet - installed view-engines with oil

filler and indicator with splash pan drain.

Note.

With the exception of the early engine

oil filler and oil level indicator tube retaining

straps (A and B, fig. 4-131), the oil coolers,

support beams, and upper cover frames on each

side of the engine are removed in the same

manner. For instructional purposes, removal of

the right oil coolers, support beams, upper cover

frames and frame support brackets are described

in the following instructions.

1. Disconnect manifold heater spark plug cable (A).

2. Cut locking wire and remove two screws (B), spacers,

and flat washers attaching ignition unit bracket to oil

coolers. Remove ignition unit, bracket, and cable.

3. Remove grommets (C) from bracket- Replace

damaged grommets.

Install

1. Position grommets (C) in bracket.

2.

Position ignition unit, bracket, and cable on oil

coolers. Install two screws (B), spacers, and flat

washers securing ignition unit bracket to oil coolers.

Lock wire screws securely.

3. Connect manifold heater spark plug cable (A) to

spark plug.

Figure 5-10. Removing or installing manifold

heater ignition unit-right side.

5-6