TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 197 of 779

Figure 5-19. Removing or installing right oil

cooler end shroud.

Remove

1. Remove self-locking nut (A), washer, and cap screw

attaching brace to support beam.

2. Remove self-locking nut (B), two spacers, bolt, and

grommet attaching brace to turbosupercharger tie rod.

3. Remove six self-locking nuts (C) and three flat

washers attaching support beam to cylinders and

rem ove beam.

Install

Note.

The flat washers are located at cylinder

Nos. 3, 4 and 5 on both cylinder banks.

1. Position support beam on engine and install six self-

locking nuts (C) and three flat washers securing beam

to cylinders.

2. Install self-locking nut (B), two spacers, bolt, and

grommet securing brace to turbosupercharger tie rod.

3. Install self-locking nut (A), washer, and cap screw

securing brace to support beam.

Figure 5-20. Removing or installing

cooler support beam.

right oil

5-11