TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 199 of 779

Figure 5-22. Removing or installing right

turbosupercharger oil inlet hose and

transmission shroud.

Remove

1. Disconnect turbosupercbarger oil inlet hose (A) from

bulkhead adapter elbow and remove hose.

2. Remove two machine screws (B) attaching right

transmission shroud and remove shroud.

Note.

Left turbosupercharger oil inlet hose

and transmission shroud are removed or in-

stalled in the same manner.

Install

1. Position right transmission shroud on rear of engine

and install two machine screws (B) securing shroud.

2. Connect oil inlet hose (A) to bulkhead adapter elbow.

5-6. Manifold Heater Tubes, Solenoids,

and Filter, Cylinder Head Oil

Drain Lines, and Intake Manifold

Assemblies

Refer to Table 5-3 for illustrations and

disassembly instructions. Figure references are

listed in the table.

Table 5-3. Manifold Heater Tubes, Solenoids and Filter, Cylinder

Head Oil Drain Lines, and Intake Manifold Assembly-

Component

Figure Reference

Manifold Heater Tubes, Hoses, Fuel Check Valve, Fuel

5-23 through 5-27

Filter, Bracket. and Solenoid Valves

Cylinder Head Oil Drain Tubes

5-28 through 5-32

Intake Manifold, Manifold Heater, and Turbosupercharger

5-33

Air Outlet Elbow

Remove

1. Remove machine screw (A) attaching right manifold

beater fuel return tube clamp to right rear shroud.

2. Disconnect fuel return tube (B) from heater and tube

tee. Remove tube.

Note.

Left manifold heater fuel return tube is

removed or installed in the same manner.

Install

1. Position right manifold heater fuel

return tube (B) on

right rear shroud and connect to heater and tube tee.

2. Install machine screw (A) securing fuel return tube

clamp to right rear shroud.

Figure 5-23. Removing or installing right

manifold heater fuel return tube.

5-13