TM-9-2815-200-35
ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)
TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
TM-9-2815-200-35 - Page 207 of 779
Remove
1. Disconnect fuel outlet hose (A) from elbow in
fuel / water separator filter and remove hose.
2. Disconnect and remove fuel inlet hose (B).
3. Remove fuel inlet and outlet elbows and drain tube
elbow (C) from filter.
4. Disconnect and remove fuel/ water separator filter
fuel drain tube (D).
5. Remove lower two cap screws (E), lock washers, and
plain washers.
6. Remove upper two cap screws (F), lock washers, and
plain washers attaching fuel / water separator filter to
mounting bracket. Remove filter.
Install
1. Position fuel/ water separator filter on mounting
bracket and install upper two cap screws (F), lock
washers, and plain washers securing filter to bracket.
2. Install lower two cap screws (E), lock washers, and
plain washers.
3. Install fuel inlet and outlet elbows and drain tube
elbow (C) in filter.
4. Position fuel/ water separator filter fuel drain tube
(D) under filter and connect tube to filter.
5. Connect fuel inlet hose (B) to filter.
6. Connect fuel outlet hose (A) to elbow in filter.
Figure 5-38. Removing or installing
fuel/ water separator filter.
Remove
1. Remove cotter pin, slotted nut (A), flat washer, and
bolt Separate adjustable control rod from cross shaft
lever.
2. Remove two cap screws (B) and lock washers at-
taching primary fuel filter mounting bracket to cylinder
No. 1 R. Remove mounting bracket.
3. Remove cap screw (C) and lock washers attaching
camshaft end plate to cylinder No. 1R.
4. Remove two assembled washer bolts (D) attaching
cross shaft bracket. Remove bracket, end plate with
tachometer drive adapter, and throttle linkage cross
shaft as a unit. Separate cross shaft from camshaft end
plate. Remove and discard camshaft end plate gasket.
Install
1. Install new camshaft end plate gasket. Install throttle
linkage cross shaft in camshaft end plate. Position cross
shaft bracket, end plate with tachometer drive adapter,
and cross shaft as a unit on right front shroud. Install
two assembled washer bolts ( D) securing cross shaft
bracket.
2. Install cap screw (C) and lock washer securing
camshaft end plate to cylinder No. 1 R.
3. Position primary fuel filter mounting bracket on
cylinder No. 1 R and install two cap screws (B) and lock
washers securing bracket to cylinder.
4. Position cross shaft lever and adjustable control rod
and install bolt, flat washer, slotted nut (A) and cotter
pin.
Figure 5-39. Removing or installing primary
fuel filter bracket, throttle linkage cross
shaft, and camshaft end plate.
5-21
Back to Top
