TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 211 of 779

Remove

1. Remove three machine screws (A) and remove left

front shroud.

2. Remove eight plate nuts (B) from shroud.

Note.

Remove or install cylinder baffle from

cylinder No.

1L

after

left

front

shroud

is

removed and in the same manner as cylinder

baffle No. lR was removed (fig. 5-44). Cylinder

baffle for cylinder No. 6R is identical and in-

terchangeable with baffle for cylinder No. 1L

and is also removed or installed in the same

manner.

Install

1. Install eight plate nuts (B) on left front shroud.

2. Position left front shroud on engine and install three

machine screws (A).

Figure 5-47. Removing or installing left

front shroud.

Remove

1. Remove two machine screws (A).

2. Remove three machine screws (B) and lock washers

attaching top filler plate to crankshaft damper and oil

filter housing. Remove top filler plate.

3. Remove three machine screws (C) and lock washers

attaching side filler plate to housing.

4. Remove three machine screws (D) attaching side filler

plate to left front shroud and remove filler plate.

Install

1. Position side filler plate on left front shroud and install

three machine screws (D) securing plate to shroud.

2. Install three machine screws (C) and lock washers

securing side filler plate to crankshaft damper and oil

filter housing.

3. Position top filler plate on housing. Install three

machine screws (B) and lock washers securing plate to

housing.

4. Install two machine screws (A).

Figure 5-46. Removing or installing top and

side filler plates-cylinder No. 1L.

5-25