TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 202 of 779

Remove

1. Loosen hose clamps

(A).

2. Loosen hose clamps (B) and remove cylinder head oil

drain tube, hoses, and turbosutpercharger oil drain tube.

Note.

The right rear cylinder head oil drain

tube was disconnected from the oil pan to

facilitate removal of the generator (fig. 4-13).

Install

1. Position turbosupercharger oil drain tube, hoses, and

cylinder head oil drain tube and tighten hose clamps

(B).

2. Tighten hose clamps

(A).

Figure 5-28. Removing or installing right

rear cylinder head oil drain tube and

turbosupercharger oil drain tube.

Disconnect

1. Remove two cap screws

(A)

and

lock washers at

taching right front cylinder head oil drain tube to oil

pan.

2. Separate drain tube from pan and remove and discard

drain tube gasket (B).

Connect

1. Install new drain tube gasket (B) and position right

front cylinder head oil drain tube on oil pan.

2. Install two cap screws (A) and lock washers securing

drain tube to oil pan.

Figure 5-29. Disconnecting or connecting

right front cylinder head oil drain tube.

Disconnect

1. Remove two cap screws (A) and lock washers at-

taching left front cylinder head oil drain tube to oil pan.

2. Separate drain tube from pin and remove and discard

drain tube gasket (B).

Connect

1. Install new drain tube gasket

(B)

and position left

front cylinder head

oil drain tube on oil pan.

2. Install

two cap screws

(A)

and lock washers securing

drain tube to

oil pan.

Figure 5-30. Disconnecting or connecting

left front cylinder head oil drain tube.

5-16