TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 206 of 779

Remove

1. Disconnect fuel outlet hose (A) from elbow in

secondary fuel filter and bulkhead elbow in left front

shroud and remote hose.

2. Disconnect and remove fuel inlet hose (B).

3. Remove elbows and pipe reducers (C).

4. Disconnect and remove secondary fuel filter fuel drain

tube (D).

5. Remove four cap screws (E) and lock washers at-

taching secondary fuel filter to mounting bracket.

Remove filter.

Install

1. Position secondary fuel filter against mounting

bracket and install four cap screws (E) and lock

washers securing filter to bracket.

2. Position secondary fuel filter fuel drain tube (D)

under filter and con nect tube to filter.

3. Install elbows and pipe reducers (C) in filter.

4. Connect fuel inlet hose (B) to filter.

5. Connect fuel outlet hose (A) to bulkhead elbow in left

front shroud and elbow in filter.

Figure 5-36. Removing or installing

secondary fuel filter.

Disconnect

1. Disconnect fuel outlet hose (A) from bulkhead elbow.

2. Remove nut (B) attaching fuel outlet hose clamp to

lifting eye stud.

Note.

Re-install

nut on lifting eye stud and

tighten. Lifting eye will be used for oil filter and

damper housing assembly removal.

Connect

1. Remove nut (B) from lifting eye stud. Install fuel

outlet hose clamp on stud and re-install nut (B).

2. Connect fuel outlet hose (A) to bulkhead elbow.

Figure 5-37. Disconnecting or connecting

fuel/ water separator fuel outlet hose

from bulkhead elbow.

5-20