TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 210 of 779

Remove

1. Remove two plate nuts (A) from cylinder baffle.

2. Remove cylinder baffle (B).

Note.

Cylinder baffles for cylinder Nos. lR

and 6L are-identical and are removed or installed

in the same manner.

Install

1. Position cylinder baffle (B) over cylinder.

2. Install two plate nuts (A) on cylinder baffle.

Figure 5-44. Removing or installing cylinder

baffle-cylinder No. lR.

Disconnect

1. Disconnect fire extinguisher tube (A) from adapter.

2. Remove nut (B) attaching adapter to shroud and

remove adapter.

3. Disconnect fuel injection pump fuel inlet hose (C)

from bulkhead elbow.

4. Remove nut (D) and external teeth lock washer at-

taching bulkhead elbow to shroud. Remove elbow and

flat washer.

S. Remove four nuts (E). external teeth lock washers.

and machine screws attaching fuel injection pump fuel

cutoff lead to shroud. Remove lead from shroud.

Connect

1. Position fuel injection pump fuel cutoff lead through

shroud. Install four nuts (E), external teeth lock

washers, and machine screws securing lead to shroud.

2. Position bulkhead elbow and flat washer in shroud.

Install nut (D) and external teeth lock washer securing

elbow to shroud.

3. Connect fuel injection pump fuel inlet hose (C) to

bulkhead elbow.

4. Position adapter in shroud and install nut (B)

securing adapter to shroud.

5. Connect fire extinguisher tube (A) to adapter.

Figure 5-45. Disconnecting or connecting

fire extinguisher and fuel inlet tubes-

front shroud.

5-24