TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 215 of 779

Remove

1. Remove three assembled washer bolts (A) and seal

washers and remove oil filler tube and cap as a unit.

Discard seal washers.

2. Remove and discard oil filler tube gasket (B).

3. Remove three self-locking nuts (C) and remove oil

level indicator tube and cap as a unit.

4. Remove and discard oil level indicator tube gasket

(D).

Install

1. Install a new oil level indicator tube gasket (D) on oil

pan,

2. Position oil level indicator tube and cap as a unit on oil

pan. Install three self-locking nuts (C) securing tube.

3. Install a new oil filler tube gasket (B) on oil pan.

4. Position oil filler tube and cap as a unit on oil pan.

Install three assembled washer bolts (A) and new seal

washers securing tube.

Figure 5-53. Removing or installing oil filler

and oil level indicator tubes-engines

Remove

1. Remove two machine screws (A) and lock washers

and remove cylinder head plate at oil filler tube.

2. Remove two machine screws (B) and lock washers

and remove cylinder head plate at oil level indicator

tube.

Install

1. Position cylinder head plate at oil level indicator tube

position. Install two machine screws (B) and lock

washers securing plate.

2. Position cylinder head plate at oil filler tube position.

Install two machine screws (A) and lock washers

securing plate.

Figure 5-54. Removing or installing cylinder

head plates at oil filler and oil level

indicator tubes-engines without

splash pan installation.

with one piece oil filler tube.

5-29