TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 222 of 779

Remove

1. Remove special bolts (A) attaching fuel tube elbow

connector to nozzle and holder in cylinder No. 1 R.

2. Remove and discard elbow connector gaskets (B)

from bolt as bolt and elbow connector are separated.

3. Remove five special bolts (C) attaching fuel tube

connectors to nozzle and holder assemblies in cylinder

Nos. 2R, 3R, 4R, 5R, and 6R.

4. Remove and discard connector gaskets (D) from bolts

as bolt and connector are separated.

Note.

Fuel injector nozzle fuel tube connectors

and elbow connectors on left side of engine are

removed or installed in the same manner.

Install

1. Position a new connector gasket (B) on special bolt

(A), insert bolt through fuel tube efbow connector, and

position second new connector gasket (B) on bolt.

2. Install assembled special bolt (A), with gaskets and

elbow connector in nozzle and holder at cylinder No.

1R.

3. Position a new connector gasket (D) on special bolt

(C), insert bolt through fuel tube connector, and

position second new connector gasket (D) on bolt.

4. Install five assembled special bolts (C), with gaskets

and tube connectors in nozzle and holder assemblies at

cylinder Nos. 2R, 3R, 4R, 5R and 6R.

Figure 5-63. Removing or installing fuel

injector nozzle fuel tube connectors and

elbow connector-right side.

5-36