TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 223 of 779

Remove

1. Remove eight self-locking nuts (A) and bolts. Remove

four plates and eight tube clamps from four left tube

clamp supports.

2. Remove four self-locking nuts (B) and bolts. Remove

two plates and four tube clamps from double tube

clamp support.

3. Remove four self-locking nuts (C) and bolts. Remove

two plates and four tube clamps from double angle and

single angle brackets.

4. Remove four self-locking nuts (D) and bolts. Remove

two plates and four tube clamps from two right tube

clamp supports.

Install

Note.

Some engines were provided with four

additional clamps to minimize the vibration of

the fuel injection

tube. When overhaulin g

engines,

install tube clamping to the current

clamping

arrangement,

as described in in-

structions which accompany figure 5-65 and to

dimensions shown in figures 4-41 and 4-42.

Figure 5-64. Removing fuel injector clamps-engines without

additional clamps.

5-37