TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 216 of 779

Remove

Note.

The oil filler and oil level indicator tubes

must be removed before cylinder head plates

between cylinders Nos. 1L, 2L and 3L can be

removed.

1. Remove two hex head screws (A) and lock washers

and remove oil filler tube plate.

2. Remove two hex head screws (B) and lock washers

and remove oil level indicator tube plate.

3. Remove and discard grommet (C).

Install

1. Install a new grommet (C) in oil level indicator tube

plate.

2. Position indicator tube plate and install two hex head

screws (B) and lock washers securing plate.

3. Position oil filler tube plate and install two hex head

screws (A) and lock washers securing plate.

Figure 5-55. Removing or installing oil filler

and oil level indicator tubes-engines with

splash pan installation.

Remove

1. Remove three assembled washer bolts (A) and seal

washers and remove oil filler tube. Discard seal

washers.

2. Remove and discard oil filler tube gasket (B).

3. Remove pan head screw (C) and self-locking nut and

remove two hose clamps from oil level indicator tube.

4. Remove three self-locking nuts (D) and remove oil

level indicator tube.

5. Remove and discard oil level indicator tube gasket

(E).

Install

1. Install a new oil level indicator tube gasket (E) on oil

pan.

2. Position oil level indicator tube on oil pan. Install

three self-locking nuts (D) securing tube.

3. Position two hose clamps, one on indicator tube, and

install pan head screw (C) and self-locking nut securing

clamps.

4. Install a new oil filler tube gasket (B) on oil pan.

5. Position oil filler tube on oil pan. Install three

assembled washer bolts (A) and new seal washers

securing tube.

Figure 5-56. Removing or installing oil filler

and oil level indicator tube plates -

engines with splash pan installation.

5-30