TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 182 of 779

Remove

1. Remove two bolts (A) and flat washers attaching

intake valve adjusting screw cover plate.

2. Remove cover plate and gasket (B). Discard gasket.

Install

1. Position new gasket (B) on cylinder and install intake

valve adjusting screw cover plate.

2. Install two bolts (A) and flat washers securing cover

plate.

Figure 4-194. Removing or installing intake

valve cover plate.

Remove

1. Remove three screws (AI attaching end shroud to top

support and to tab on cylinder head.

2. Refer to figure 4-147 for removal of three screws (B)

attaching shroud to inner shroud plate. Remove shroud.

Iustall

1. Position end shroud with inner shroud plate and refer

to figure 4-147 for installation of three screws (B)

securing shroud to shroud plate.

2. Install three screws (A) attaching shroud to top

support and to tab on cylinder head.

Figure 4-193. Removing or installing oil

cooler end shroud.

Figure 4-195. Cross section of cylinder 6R

showing position of camshaft lobes for

valve timing.

4-100