TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 360 of 856
INSTALLATION - Continued
15.
Lower fuel injector rocker arm (Figure 31, Item 3) onto fuel injector plunger follower (Figure 31, Item 4).
NOTE
The rocker arm shaft has matched upper and lower through-shaft pathway bolt holes at
each end of the shaft. The through-shaft pathway holes must be rotated until aligned with
the corresponding vertical through-bolt holes in both the front rocker arm shaft bracket and
throttle delay assembly. The mounting/machine bolts cannot be installed if this alignment is
not achieved. Pre-align shaft pathway holes with bracket and delay assembly through-bolt
holes before fully installing rocker arm shaft.
16.
Position throttle delay assembly (Figure 31, Item 18) next to rear exhaust valve rocker arm
(Figure 31, Item 2). Align bases of front rocker arm shaft bracket (Figure 31, Item 17) and throttle delay
assembly (Figure 31, Item 18) with threaded mounting holes in engine cylinder head assembly.
18
17
2
18
3
4
MAINT_472
Figure 31.
Throttle Delay Assembly Reposition.
TM 9-2815-205-24
0054
0054-22
Back to Top
