TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 722 of 856
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA - CYLINDER LINER
1.
Check outside of liner for cracks, scoring, and flange irregularities. Discard cracked or excessively scored
liners. Clean up lightly scored liners using cylinder hone.
NOTE
Excessive liner to block clearance or block bore distortion will reduce heat transfer from
liner to block.
2.
Examine outside surface for fretting. Remove metal particles from outer surface with sharpening stone.
3.
Liner flange must be smooth and flat on top and bottom surfaces. Replace if cracked at flange.
4.
Check inside diameter of liner for glazing, cracking, scoring, and unusual wear. Replace cracked, scuffed, or
scored liners.
GLAZE
UNBROKEN
GLAZE
BROKEN
MAINT_388
Figure 2.
Cylinder Liner Inspection.
END OF TASK
MEASUREMENTS - CYLINDER LINER
1.
Measure outside diameter of liner at (Figure 3, Items A and B). Diameter (Figure 3, Item A) must be
4.485–4.486 in. (113.92–113.94 mm), diameter (Figure 3, Item B) must be 4.355–4.356 in.
(110.62–110.64 mm).
A
B
A
B
MAINT_389
Figure 3.
Cylinder Liner Measurements.
TM 9-2815-205-24
0096
0096-4
Back to Top
