TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 714 of 856

INSTALLATION

CAUTION

Cylinder block bore grooves must be clean. Debris in grooves will cause coolant leakage

into engine oil and engine damage can result.

NOTE

If any pistons and liners are already in engine, use cylinder liner hold-down clamp

(Figure 13, Item 2) to retain liners (Figure 13, Item 1) in place when crankshaft is rotated.

1.

Install two preformed packings (Figure 13, Item 31) in cylinder block bore grooves.

2.

Apply shortening compound or antifreeze to inner surface of preformed packings (Figure 13, Item 31).

3.

Rotate crankshaft (Figure 13, Item 4) until connecting rod journal of cylinder is at bottom of its travel. Wipe

journal clean and lubricate with clean engine oil.

NOTE

Tang on bearing shell must fit in indentation on connecting rod.

4.

Install upper bearing shell (Figure 13, Item 32) (without continuous oil groove) in connecting rod

(Figure 13, Item 22). Lubricate bearing shell with clean engine oil.

TM 9-2815-205-24

0095

0095-18