TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 309 of 596

TM9-2815-205-34

3-49. END PLATE REPLACEMENT (Cont)

d. Assembly

If screw inserts (7) were removed, support end plate (3) on flat surface and press screw inserts into

plate from front until insert seats on end plate.

(1)

(2)

(3)

(4)

(5)

Install gasket (6) on rear of cylinder block using gasket adhesive.

Apply a coat of gasket adhesive to outer surface of gasket (6).

Align holes in end plate (3) with dowels (8) in cylinder block. Push end plate against cylinder

block.

Install ten Iockwashers (5) and ten screws (4). Torque screws to 30-35 Ib-ft (41-47 N

.

m).

On all except model 5063-5393. install

END OF TASK

FOLLOW-ON MAINTENANCE

Para

3-48

3-47

3-44

3-40

3-33

3-28

3-29

3-23

3-5

3-6

3-3

Description

Install camshafts, camshaft gears, and idler gear.

Install fuel pump and hydraulic pump drive assemblies.

Install flywheel housing.

Install flywheel assembly.

Install oil pan.

Install tachometer drive (models 5063-5299, 5063-5392, 5063-5393, and 5063-539F).

Install tachometer drive (models 5063-5395 and 5063-5398).

Install fuel pump.

Install turbocharger mounting bracket and exhaust tubes (model 5063-5393).

Install turbocharger mounting bracket and exhaust tubes (models 5063-5395, 5063-5398,

and 5063-539F).

Install turbocharger (models 5063-5393, 5063-5395, 5063-5398, and 5063-539F).

3-176

e. Installation

special washer (2) and screw (1) on left

side of end plate. Torque screw to

71-75 lb-ft (96-102 N

.

m).