TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 33 of 596
TM 9-2815-205-34
2-2. CLEANING AND GENERAL REPAIR INSTRUCTIONS (Cont)
(b) Installation.
1. Clean repaired parts thoroughly before assembly or installation.
2. Align bushings or bushing type bearings in casting or retaining cage.
3. Press into place with arbor press or with the special tools provided.
4. Bushing type bearings are machined for proper clearance and need no reaming.
(7) Oil Seals. Oil seals must be replaced during component repair.
(a) Removal. Press or pry damaged oil seal from casting
bore in casting or adapter.
(b) Repair.
1. When oil seal bore in casting or adapter is burred
or adapter. Use care not to damage
or damaged to a point where an oil
tight seal is impossible, replace casting or adapter.
2. Remove slight nicks, burrs and scratches from bore in casting or adapter with crocus
cloth dipped in cleaning solvent.
(c) Installation. Install new oil seal in bore of casting or adapter using proper oil seal installer
tool.
d. Disassembly/Assembly Instructions.
(1) General. Exercise care in all component assembly operations to ensure satisfactory engine
performance. Precautionary rules for assembly are outlined below.
(2) Precautionary Rules.
(a)
(b)
(c)
(d)
(e)
(f)
(9)
Cleanliness is essential in all component assembly operations.
Dirt and dust, even in minute quantities, are abrasive.
Parts must be cleaned as specified and kept clean.
Wrap or cover parts and components when assembly procedures are not immediately
completed.
Coat all bearings and all contact surfaces with engine oil OE/HDO-15/40 (App C, Item 26)
to insure lubrication of parts during initial engine starting.
Replace all gaskets and preformed packings removed in disassembly. Clean and remove
all traces of gasket material from surfaces.
Store all fastening hardware (nuts, bolts, screws, Iockwashers, and flat washers) in or with
the related component to assist in reassembly.
2- 6
Back to Top
