TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 41 of 596
TM 9-2815-205-34
2-4. TRANSMISSION OIL COOLER
5063-539L) (Cont)
b. Installation
(1)
(2)
(3)
(4)
(5)
(6)
2-14
Slide hose (2) and two clamps
REMOVAL/INSTALLATION (MODELS 5063-5393, AND
(1) onto water outlet housing (4).
Transmission cooler is heavy. Provide adequate support to prevent injury to
personnel from cooler falling during installation.
Place gasket (28) on transmission oil cooler bracket (23) and install transmission oil cooler
assembIy (3) on bracket with ports facing rear of engine,
Loosely install eight flat washers (22), eight Iockwashers (21), and eight screws (20) securing
bottom of transmission oil cooler assembly (3) to bracket (23).
Slide hose (2) and two clamps (1) over top of transmission oil cooler assembly (3) and tighten
clamps.
Guide two flat washers (26),
Torque screws (20) and (24)
Change 1
two Iockwashers (25), and two screws (24) onto bracket (27).
to 13-17 Ib-ft (18-23 N•m).
Back to Top
