TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992
TM-9-2815-205-34

  TM-9-2815-205-34 - Page 50 of 596

TM 9-2815-205-34
2-8. OIL LEVEL GAGE ROD REMOVAL/INSTALLATION (MODEL 5063-5392)
This task covers: a. Removal
b. Installation
INITIAL SETUP
MODELS
MATERIALS/PARTS
5063-5392
1
Lockwasher (App F, Item 99)
TOOLS AND SPECIAL TOOLS
Tool kit, general mechanics (App B, Item 107)
Wrench, torque (App B, Item 116)
a. Removal
(1)
(2)
(3)
Remove oil gage rod (1) from tube
assembly (2).
Unscrew fitting of tube assembly (2) from
adaptor (3) in rear right side of oil pan.
Remove bolt (4), Iockwasher (5), flat
washer (6), clip (7), and tube assembly
(2) from right side of flywheel housing. If
necessary, remove clip from tube
assembly. Discard Iockwasher.
b. Installation
(1)
(2)
(3)
(4)
If removed, install clip (7) on tube
assembly (2). Loosely install tube
assembly in adaptor (3).
NOTE
Bolt (4) may already be
installed, in right side of
flywheel housing, to accom-
modate the torque sequence
when installing the flywheel
housing to the cylinder block.
Remove as required for clip
installation.
Install flat washer (6), Iockwasher (5),
and bolt (4) through clip (7). Torque bolt
to 30-35 Ib-ft (41-47 N•m).
Tighten connection at adaptor (3) and
tube assembly (2).
Install oil gage rod (1) in tube assembly
(2).
END OF TASK
2-23


Back to Top