TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992
TM-9-2815-205-34

  TM-9-2815-205-34 - Page 57 of 596

TM 9-2815-205-34
2-13. OIL FILTER ASSEMBLY AND ADAPTOR REMOVAL/INSTALLATION (MODELS 5063-5393
AND 5063-539L)
This task covers: a. Removal
b. Installation
INITIAL SETUP
MODELS
MATERIALS/PARTS
5063-5393 5063-539L
4
Lockwashers (App F, Item 99)
1
Gasket (App F, Item 32)
TOOLS AND SPECIAL TOOLS
Tool kit, general mechanics (App B, Item 107)
Wrench, torque (App B, Item 116)
a. Removal
(1) Disconnect turbocharger oil supply hose (1) from elbow (2) in oil filter and adaptor assembly (3).
(2) If necessary, remove elbow (2) from oil filter and adaptor assembly (3).
(3) Remove two short screws (4), two long screws (5), four Iockwashers (6), four flat washers (7),
gasket (8), and oil filter and adaptor assembly (3) from rear left side of cylinder block. Discard
Iockwashers and gasket.
b. Installation
(1)
(2)
(3)
Install gasket (8), oil filter and adaptor assembly (3), four flat washers (7), four Iockwashers (6),
two short screws (4), and two long screws (5) on rear left side of cylinder block. Torque screws
to 30-35 Ib-ft (41-47 N•m).
If removed, install elbow (2) in oil filter and adaptor assembly (3).
Connect turbocharger oil supply hose (1) to elbow (2) in oil filter and adaptor assembly (3).
Tighten hose connection securely.
END OF TASK
2-30
Change 1


Back to Top