TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 63 of 596
TM 9-2815-205-34
2-16. ENGINE/TRANSMISSION OIL COOLER REMOVAL/INSTALLATION (MODEL 5063-5299)
(Cont)
Oil cooler is heavy. Provide adequate support to prevent injury to personnel
from cooler falling during removal.
(6) Remove three bolts (16), three Iockwashers (17), three flat washers (18), oil cooler assembly
(14), and gasket (19) from cylinder block. Discard gasket and Iockwashers.
(7) Remove oil cooler element (20) and gasket (21) from
(8) Remove two guide studs (15) from cylinder block.
.
oil cooler assembly (14). Discard gasket.
b. Installation
(1) Install two guide studs (15) into cylinder block at positions (A) and (B).
(2) Install gasket (19), oil cooler element (20), and gasket (21) on guide studs (15) with port
marked “IN” toward front of engine and slide gaskets (19 and 21) and element (20) against
cylinder block.
(3) Position oil cooler assembly (14) on guide studs (15) and slide up against cylinder block.
2-36
Back to Top
