TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 72 of 596
TM 9-2815-205-34
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
NOTE
Center bolt (18) is installed through clip (19) into oil cooler assembly (3).
Loosely install three flat washers (21), three Iockwashers (20), and three bolts (18) on oil cooler
assembly (3). Remove two guide studs (34).
Install transmission oil cooler bracket (14), five flat washers (17), five Iockwashers (16), and five
bolts (15) on oil cooler assembly (3).
Install bracket (13), two flat washers (12), two Iockwashers (11), and two bolts (10) on
transmission oil cooler bracket (14).
Torque two bolts (10), five bolts (15), and three bolts (18) to 13-17 Ib-ft (18-23 N·m).
Slide hose (2) and two clamps (1) onto oil cooler assembly (3).
If removed, install pipe plug (9) in elbow (7).
NOTE
Front bolt (4) is installed through clip (5), on hose (35), into elbow (7).
Insert elbow (7) into hose (2) and install gasket (8), elbow (7), two Iockwashers (6), and two
bolts (4) on cylinder block. Torque bolts to 13-17 lb-ft (18-23 N·m).
Adjust hose (2) and two clamps (1) between elbow (7) and oil cooler assembly (3) with clamp
adjusting screws facing front of engine. Tighten clamps securely.
END OF TASK
FOLLOW-ON MAINTENANCE
Para Description
2-4 Install transmission oil cooler.
2-6 Install coolant pump.
2-5 Install fuel junction block.
2-13 Install oil fiter assembly and adaptor.
2-45
Back to Top
