TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 75 of 596
TM 9-2815-205-34
2-19. ENGINE OIL COOLER REMOVAL/INSTALLATION (MODELS 5063-5395,5063-5398, AND
5063-539F) (Cont)
(7)
(8)
(9)
(10)
(11)
For models 5063-5395 and 5063-539F, remove two clamps (1) and hose (2) from oil cooler
housing (3).
For model 5063-5398, remove flange (9) and seal ring (22). Discard seal ring.
Remove gasket (23), oil cooler element (24), and gasket (25) from oil cooler housing (3).
Discard gaskets.
Remove three studs (21) from cylinder block.
If necessary, remove drain cock (26) from bottom of oil cooler housing (3).
b. Installation
(1)
(2)
(3)
2-48
If removed, install drain cock (26) in bottom of oil cooler housing (3).
Install two studs (21) in cylinder block at locations (A and B) to act as guides.
Place gasket (25), oil cooler element (24), and gasket (23) on studs (21) and slide gaskets (25
and 23) and element (24) up against cylinder block.
Back to Top
