TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 83 of 596
TM 9-2815-205-34
2-21. FUEL FILTERS AND MOUNTING BRACKETS
5063-5393) (Cont)
(8)
(9)
(10)
REMOVAL/INSTALLATION (MODEL
Remove two screws (22), four flat washers (23), two self-locking nuts (24), and fuel strainer
assembly (3) from center mounting bracket (25). Discard self-locking nuts.
Remove two screws (26), four flat washers (27), two self-locking nuts (28), fuel filter assembly
(6), and pressure switch bracket (21) from center mounting bracket (25). Discard self-locking
nuts.
Remove four screws (29), four flat washers (30), four self-locking nuts (31), and center bracket
(25) from end bracket (32) and end bracket (33). Discard self-locking nuts.
(11) Remove two screws (34), four flat washers (35), two Iockwashers (36), two nuts (37), and end
bracket (33) from engine flywheel housing. Discard Iockwashers.
(12) Remove two small bolts (38), two Iockwashers (39), two flat washers (40), large screw (41),
Iockwasher (42), flat washer (43), and end bracket (32) from side of cylinder block. Discard
Iockwashers.
(13) If necessary, remove connector (2) from fuel strainer assembly (3).
(14) If necessary, remove elbow (5), elbow (8), elbow (10), connector (14), transducer (44), two tees
(45), and pipe plug (46) from fuel filter assembly (6).
2-56
Back to Top
