TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 76 of 596
TM 9-2815-205-34
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
For models 5063-5395 and 5063-539F, slide hose (2) and two clamps (1) onto oil cooler
housing (3).
For model 5063-5398, install flange (9) and seal ring (22) on oil cooler housing.
Place oil cooler housing (3) on studs (21) and slide up against cylinder block.
Install two flat washers (17), two Iockwashers (16), and two bolts (15) on oil cooler housing (3).
Remove two guide studs (21) from locations (A and B) and install remaining flat washer,
Iockwasher, and bolt in location (A). Torque bolts to 13-17 Ib-ft (18-23 N·m).
Install three studs (21), three flat washers 20), three Iockwashers (19), and three nuts (18) in
middle row of holes in oil cooler housing. Torque nuts to 15-19 Ib-ft (20-26 N·m).
NOTE
Front bolt (4) is installed through clip (5) on hose (27) at elbow (7) for models
5063-5395 and 5063-529F or at flange (9) for model 5063-5398.
For models 5063-5395 and 5063-529F, insert elbow (7) in hose (2) and install gasket (8), elbow
(7), two Iockwashers (6), and two bolts (4) on cylinder block. Torque bolts to 13-17 Ib-ft (18-23
N·m).
For model 5063-5398, install two Iockwashers (6) and two bolts (4) in flange (9) on cylinder
block. Torque bolts to 13-17 Ib-ft (18-23 N·m).
For models 5063-5395 and 5063-539F, adjust hose (2) and two clamps (1) between elbow (7)
and oil cooler housing (3) with clamp adjusting screws facing front. Tighten clamps securely.
Install gasket (14), elbow (13), two flat washers (12), two Iockwashers (11), and two bolts (10)
on oil cooler housing (3). Torque bolts to 30-35 Ib-ft (41-47 N·m).
END OF TASK
FOLLOW-ON MAINTENANCE
Para Description
2-6 Install coolant pump.
2-14 Install oil filter mounting bracket (models 5063-5395 and 5063-539 F).
2-49
Back to Top
