TM 9-2815-205-34
Oil cooler is heavy. Provide adequate support
from cooler falling during removal.
to prevent injury to personnel
(7) Remove oil cooler assembly (3) and gasket (18). Discard gasket.
(8) Remove oil cooler element (19) and gasket (20) from oil cooler assembly (3). Discard gasket.
(9) Remove three studs (21) and stud (22) from cylinder block.
(10) Remove two large screws (23), two Iockwashers (24), two flat washers (25), small bolt (26),
Iockwasher (27), flat washer (28), oil cooler adaptor (29), and gasket (30) from cylinder block.
Discard gasket and Iockwashers.
(1)
(2)
(3)
(4)
b. Installation
Install gasket (30), oil cooler
adaptor (29), two flat washers (25),
two Iockwashers (24), two large screws
(23), flat washer (28), lockwasher (27),
and small bolt (26) on cylinder block.
Torque two screws (23) to 30-35 Ib-ft
(41-47 N-m) and bolt (26) to 13-17 Ib-ft
(18-23 N·m).
Install two studs (21) in positions (A) and (B) to act as guides.
Position gasket (18), oil cooler element (19), and gasket (20) on two studs (21) with port
marked “IN” toward front of engine and slide gaskets (18 and 20) and element (19) up against
oil cooler adaptor (29).
Position oil cooler assembly (3) on two studs (21) and slide up against oil cooler adaptor (29).
2-39
WARNING