TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 71 of 596
TM 9-2815-205-34
2-18. ENGINE OIL COOLER REMOVAL/INSTALLATION (MODEL 5063-5393) (Cont)
b. Installation
(1) Install two guide studs (34) in positions (A) and (B).
(2) Install gasket (33), oil cooler adaptor (32), two flat washers (28), two Iockwashers (27), two
large screws (26), flat washer (31), Iockwasher (30), and small bolt (29) on cylinder block.
Torque two screws (26) to 30-35 Ib-ft (41-47 N·m) and bolt (29) to 13-17 Ib-ft (18-23 N·m).
(3) Install gasket (22), oil cooler element (23), and gasket (24) on guide studs (34) with port
marked “IN” toward front of engine and slide gaskets (22 and 24) and element (23) up against
cylinder block.
(4) Place oil cooler housing (25) on studs (34) and slide up against cylinder block.
2-44
Back to Top
