TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 85 of 596
TM9-2815-205-34
b. Installation
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
NOT E
Install lower small bolt (38) through clip (47) on air box drain tube.
Install end bracket (32), two flat washers (40), two Iockwashers (39), two small bolts (38), flat
washer (43), Iockwasher (42), and large screw (41) on side of cylinder block. Torque two bolts
(38) to 13-17 Ib-ft (18-23 N·m) and torque screw (41) to 30-35 Ib-ft (41-47 N-m).
Install two screws (34), four flat washers (35), end bracket (33), two Iockwashers (36), and two
nuts (37) on engine flywheel housing. Torque screws to 240-250 Ib-ft (326-340 N·m).
Install four screws (29), center mounting bracket (25), four flat washers (30), and four
self-locking nuts (31) on end bracket (32) and end bracket (33). Torque screws to 30-35 Ib-ft
(41-47 N-m).
Install two screws (26), pressure switch bracket (21), fuel filter assembly (6), four flat washers
(27), and two self-locking nuts (28) on center mounting bracket (25). Torque screws to 30-35
Ib-ft (41-47 N·m).
Install two screws (22), fuel strainer assembly (3), four flat washers (23), and two self-locking
nuts (24) on center mounting bracket (25). Torque screws to 30-35 Ib-ft (41-47 N-m).
If removed, install elbow (5), elbow (10), connector (14), two tees (45), transducer (44), elbow
(8), and pipe plug (46) on fuel filter assembly (6) as shown.
If removed, install connector (2) on fuel strainer assembly (3).
If removed, install elbow (11) and connector (15) in pressure switch (12).
Install pressure switch (12), pad (19), pad bracket (20), two flat washers (18), two Iockwashers
(17), and two bolts (16) on pressure switch bracket (21). Loosely tighten bolts.
2-57
Back to Top
