TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 90 of 596
TM 9-2815-205-34
b. Installation
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Install gasket (23), water cover (22),
filter mounting bracket (16), special
washer (21), two flat washers (20), three
Iockwashers (19), two long screws (18)
(into right cylinder head), and screw (17)
30-35 lb-ft (41-47 NŽm).
into flywheel housing). Torque screws to
NOTE
To install two screws (15) in upper section of fuel filter assembly, remove the lower
canister due to interference (Para 2-37).
Install two screws (15), fuel filter assembly (6) , fuel strainer assembly (3), two flat washers (14),
two Iockwashers (13), and two nuts (12) on filter mounting bracket (16). Torque nuts to 30-35
lb-ft (41-47 N•m).
Install pipe plug (11) and three elbows (5, 8, and 10) in fuel filter assembly (6).
Install elbow (2) in fuel strainer assembly (3).
Connect hose assembly (9) to outlet port elbow (10) in fuel filter assembly (6). Tighten hose
connection.
Connect hose assembly (7) to outlet port elbow (8) in fuel filter assembly (6). Tighten hose
connection.
Connect hose assembly (4) to inlet port elbow (5) in fuel filter assembly (6). Tighten hose
connection.
Connect hose assembly (1) to outlet port elbow (2) in fuel strainer assembly (3). Tighten hose
connection.
END OF TASK
2-63
Back to Top
