TM 9-2815-210-34-2-1
3-38. CRANKSHAFT REAR OIL SEAL AND HOUSING.
FRAME 1
1.
2.
3.
4.
5.
NOTE
Some engines do not have oil seal housing gasket (l).
On these engines, flywheel housing gasket (2) cannot
be taken off until crankshaft rear oil seal housing (3)
is taken off.
When working on an engine with an oil seal housing gasket (1), take off fly-
wheel housing gasket (2) and throw it away.
NOTE
Most engines do not have two lockplates (4).
Bend back tabs on lockplates (4).
Take out six screws and lockwashers (5)
and two lockplates (4).
Take off crankshaft rear oil seal housing (3) and oil
seal (6).
Using a small punch, drive oil seal (6) out of rear oil seal housing (3). Throw
away oil seal.
When working on an engine with an oil seal housing gasket (1), take it off
and throw it away.
If working on an engine which does not have an oil seal housing gasket (1),
take off flywheel housing gasket (2) and throw it away.
END OF TASK
3-157