TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 197 of 259

TM 9-2815-210-34-2-1

Soldier A 1 .

Using engine barring tool, hold crankshaft damper and pulley (1)

so it cannot turn to the right.

Soldier B 2 .

Hold flywheel (2) against crankshaft so it will not fall when

lockbolts (3) are taken out.

While holding flywheel against

crankshaft, take out five lockbolts (3).

Soldiers 3 .

Hold up flywheel (2) and slide it back clear of pilot stud (4) and

A and B

off. Set flywheel down on wood blocks.

Soldier A 4 .

Mark crankshaft flange (5) around hole for pilot stud (4) with

lacquer.

Take out pilot stud (4).

END OF TASK

3-149