TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 192 of 259

TM 9-2815-210-34-2-1

3-36. FLYWHEEL .

Engines LD-465-1, LD-465-1C, and LDT-465-1C.

NOTE

One threaded hole in crankshaft flange (1) and one

mounting hole in flywheel (2) are offset about 1/16 inch.

Because of this, flywheel (2) can be put back on crank-

shaft flange (1) in only one position.

1.

Scribe a line on crankshaft flange (1) and edge of flywheel (2),

so flywheel can be put back in same position on crankshaft flange.

Soldier A 2.

Using engine barring tool, hold crankshaft damper and pulley (3)

so it cannot turn to the right.

Soldier B 3.

Take top lockbolt (4) out of flywheel.

GO TO FRAME 2

TA 087689

3-144