TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 186 of 259

TM 9-2815-210-34-2-1

FRAME 2

1.

Join lifting sling (1) to front cylinder head assembly (2) using

screw and flat washer ( 3) and nut and flat washer (4) as shown.

CAUTION

Soldier A

Soldier B

Soldiers

A and B

Make sure chain hoist (5) is in position directly above

cylinder head assembly (2) to be taken out. Cylinder

head assembly must be lifted straight up or mounting

studs at top of engine (6) may be bent.

2.

Hook chain hoist (5) to lifting sling (1). Guide cylinder head (2)

straight up while soldier B lifts it.

3.

Work chain hoist (5) to lift front cylinder head assembly (2) off

engine (6).

Set front cylinder head assembly down on workbench.

4.

Do steps 1, 2, and 3 again for rear cylinder head assembly (7).

GO TO FRAME 3

3-138