TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

  TM-9-2815-210-34-2-1 - Page 179 of 259

TM 9-2815-210-34-2-1
FRAME 2
1.
2.
3.
WARNING
Do not use less than six universal mounting arms. Using
less than six arms may cause the stand to fall, causing
damage to equipment and injury to personnel.
NOTE
Capscrews used to mount engine accessories will be used
to mount engine to maintenance stand. Universal mount-
ing arms will be placed as far apart as practical and at
various angles.
Do not tighten capscrews until all capscrews are put in
place.
Working on crank handle side of engine stand, put two universal mounting
arms (1) in place on mounting plate (2). Put in two capscrews (3).
Put two L-shaped brackets (4) in place on engine block (5).
Put in two capscrews (6).
GO TO FRAME 3
TA 118083
3-131


Back to Top