TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 193 of 259

TM 9-2815-210-34-2-1

NOTE

Tell machine shop to make pilot stud (1). See figure

3-3.

1.

Put pilot stud (1) in hole of flywheel (2) as shown.

Soldier A 2 .

Using engine barring tool, hold crankshaft damper and pulley (3)

so it cannot turn to the right.

Soldier B 3 .

Hold flywheel (2) against crankshaft so it will not fall when lock-

bolts (4) are taken out.

While holding flywheel against crankshaft,

take out five lockbolts (4).

Soldiers 4 .

Hold up flywheel (2) and slide it back clear of pilot stud (1) and

A and B

take it off. Set flywheel down on wooden blocks.

Soldier A 5 .

Take out pilot stud (1).

END OF TASK

TA 087690

3-145