TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 199 of 259

TM 9-2815-210-34-2-1

NOTE

Tell machine shop to make pilot stud (1). See figure

3-3.

1.

Put pilot stud (1) through hole in flywheel (2) and flexible transmission

plates (3) and tighten as shown.

2.

Make a scribe mark (4) on transmission drive ring (5) next to pilot stud (1)

as shown.

Make a second pair of scribe marks (6) near edge of outer flexible

drive plate (3) and on inner lip of flywheel (2) opposite pilot bolt (1) as

shown.

GO TO FRAME 3

TA 087695

3-151