TM-9-2815-210-34-2-1
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2
APRIL 1981
TM-9-2815-210-34-2-1 - Page 60 of 259
TM 9-2815-210-34-2-1
1.
Take off and throw away flame heater intake manifold elbow gasket (l).
2.
Loosen hose clamp (2) and take out crankcase breather tube (3).
NOTE
If engine has flame heater cover (4), this cover will be
used later to tell what type of flame heater is used on
this engine. It must be put back now for htis purpose.
3.
Put back flame heater cover (4). Put back four screws and starwashers (5).
4.
Unscrew two nuts (6) and take off oil inlet tube (7).
5.
Take out two screws and lockwashers (8) and take off oil inlet tube adapter
(9). Take off and throw away adapter gasket (10).
GO TO FRAME 4
3-12
Back to Top
