TM-9-2815-220-24

AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL FOR AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

  TM-9-2815-220-24 - Page 916 of 1563

TM 9-2815-220-24
FUEL INJECTION TUBES REPLACEMENT
0113 00
INSTALLATION (Continued)
16. Install floating clamps in location shown in illustration (see detail G).
CAUTION
When bending injection tubes is required, be careful not to nick
tubing.
The bending tools are designed to allow bending without
nicks.
a. Assure that fairlead halves (28) are aligned with tubes to fit within 1/8 inch (3.175 mm) in
any direction.
Use two bending tools (24) (item 13, WP 0177).
b. Apply a small amount of Lubriplate (item 23, WP 0173) to threads of four screws (25).
c. Install retainers (30) fairlead halves (28), and strap (37) using screws (25) with new self-
locking nuts (27) (item 38, WP 0175).
d. Tighten screws (25) to 160-180 inch-pounds (18-20 N
m).
Damper
End
Left Bank
Right Bank
25
30
37
27
28
30
G
24
G
WP 0113 00-12


Back to Top