TM-9-2815-220-24

AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL FOR AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

TM-9-2815-220-24 - Page 917 of 1563

TM 9-2815-220-24

FUEL INJECTION TUBES REPLACEMENT

0113 00

INSTALLATION (Continued)

17. Install floating clamp in location shown in illustration (see detail H).

CAUTION

When bending injection tubes is required, be careful not to nick

tubing.

The bending tools are designed to allow bending without

nicks.

a. Assure that clamp half (38) does not interfere with cooling fan and that tubes are parallel

with each other.

Use two bending tools (24) (item 13, WP 0177).

b. Apply a small amount of Lubriplate (item 23, WP 0173) to threads of one screw (39).

c. Install clamp halves (38, 40), using screw (39) with new self-locking nut (41) (item 111,

WP 0175) and two flat washers (42) as shown.

d. Tighten screw (39) to 75-100 inch-pounds (8.5-11.3 N

•

m).

Left Bank

Right Bank

Damper End

H

24

41

40

38

42

42

39

H

WP 0113 00-13