TM-9-2815-220-24

AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL FOR AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

  TM-9-2815-220-24 - Page 918 of 1563

TM 9-2815-220-24
FUEL INJECTION TUBES REPLACEMENT
0113 00
INSTALLATION (Continued)
18. Install lower fairlead half (43) between tube assembly and angle bracket (44) (see detail I).
CAUTION
When bending injection tubes is required, be careful not to nick
tubing.
The bending tools are designed to allow bending without
nicks.
19. Assure that fairlead half (43) is aligned with bracket (44) holes and align tube to fit within
1/8 inch (3.175 mm) in any direction with fairlead half.
Use two bending tools (24) (item 13,
WP 0177).
20. Install upper fairlead half (45) (see detail I).
a. Apply a small amount of Lubriplate (item 23, WP 0173) to threads of screw (35).
b. Install fairlead half (45) and retainer (46) using screw (35) with new self-locking nut (27)
(item 38, WP 0175).
c. Tighten screw (35) to 160-180 inch-pounds (18-20 N
m).
27
43
44
46
45
35
24
I
I
WP 0113 00-14


Back to Top