TM-9-2815-220-34
ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED, 12-CYLINDER, ASSEMBLY; MODELS AVDS-1790-2C (2815-00-410-1203) AND AVDS-1790-2D (2815-00-410-1204)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
TM-9-2815-220-34 - Page 172 of 532
TM 9-2815±220²34
()
Install bracket assembly (fig. 2-136) and
secu
r
e
·
To oil coOLer frame wiTh Two capscrews and
seLf ±locking nuTs² ³nsTal´ THree reTaining stRaps and
secure To tHe Two brackeT assemblµes w¶Th s¶x cap¸
screws and self¹´Ockµng nutsº »nstal´ man¶fold p¼e½
HeaT cable connector¾
±k²
¿nsTall loOp clamP (Fig. ÀÁ135) on sTarTer
cable and secure To inTake man¶Fold w¶TH selF±lÂkµng
nUtà ³nsta´´ ´ÄP c´amP on starter cab´e and secUÅE to
crankcase w¶TH caPscrew and selF¹lOCking nuTÆ ³nsTa´l
loop c´amp on w¶rµng Harness and secure To crankCase
wµTH capscrew and se´F±lockiÇAg nÈTÉ
³l´
»nsta´´
sTarter
´ow
vo´tage
ProTectµve
module cabLe tErmina±
´uG
(I
0, fg.
³·
l
´µ
)
,
and two
staRteR E±eCtrI²A± cab±³s (9) (cirCu´T Noµ 81¶ o·
BattEry t¸rM¹na± ºnd seCur»
WiÊË
hexAgon ¼Ut ºnD
½ockwashE¾ (8¿ À
. µm¶
»
Á
sl
a
´´
capscr³W aÁd F½a wasHe¾ Ã7j oÁ
groÄÅÆ strap Ã6) and sEÇÄr» to sÂAÈter
supPort·
¸n}
³nsTaÌl sÍarTer ground sTrap (6) and Íwo
sÍarter ground cables (Î) and secure wµTH heXagon nuT
and lOckwasHer (4)Ï ³nsTalL starTer low VolTage proÐecÑ
Tive module cable connecTor (3)² »nsÍall lOOp clamP (Ò)
on sTarÍer cables and w¶ring Harness and secure To
crankcase wÓTH capscrew and ´Ôkwasher (1)Õ
b.
MOeL
AVDS¶l 7¸¹º»D¼
Ö×Ø
Re¹ºva»
¼A½
ÙemoÚe sTarTer cables and w¶ring Harness
as ouTl¶ned in paragraph 2-49aÛ(Ü) ThrougH
¾h¿À
ÁbÂ
Ùemove two capscrews, ´oÝkwasher and FlaT
wasHers (FigÞ 2¹×ß6) and remove generaTor a¶r ¶nTakà
tÈbe From generaTor blower moTor Hoás¶ngÞ
Figure
2-146.
RemoUIng o± ²³•Ja/l´Ng gcµe¶a·or O¸± ¹º »AkE ¼½be,
AYDS·L 790.2D±
(â) Ùemove oãl temperaTure and oãl PressÈre
cable äonnecTors and Wir¶ng Harness as ouTl¶ned in
parå 2-49aæ (¶)Þ
½¾¿À
Change Á
ÃdÄ
Ùemoçe FoÈr macH¶ne screwsè lÂkwasHers
and HeXagon nuTs (éê F¶g² 2±ë47) and remove Transì
m¶ss¶on d¶sconnecT cable connecTor (2) FroM brackeT
(í)å Ùemove se´f ±´Âking nuT and Flat wasHer (4) and
remove generaTor cab´e
Å5Æ
and elecT¼ical cable (î)
and (ï)à »nsTall selF ðñÂk¶ng nòt and FlaT washeró
Ùemove selF-locking nuT and FlaT wasHerô Ùemove
selF ±lockµng nuT and flaT washer (8) and remove elec½
Trµca´ cab´e (9)õ »nsta´´ se´f ±´Âkµng nUT and flaT
wasHer² Ùemove selF±lÂk¶ng nuT and Flat wasöer (÷0)
and remove elecTr¶cal cable (×1)Ï »nsTall selF øloùk¶ng
nuT and úlaT wasHerÞ
1
Machine scrEw, lokwASHCR ±Nd hexAgON
nu²
³
²AbLe cON³ec´Oµ
´
Bracket
4
Slf±Loking
³u´ A³D ¶A´ WA·heR
6
Ge³e¸a´¹r cAbºe
µ
»le¼´½Ic¾l ¼Able
¶
»¿ectrIcal ÀAbÁe
8
se²f³²OCkINg
³UÂ AÃD ÄAT WAÅhÆÇ
¸
»ÈecÉrÊcAË ÀAbÌe
¹º
S´µ·²¶k¸¹g
³ÍÉ A³D fl±T WAÎheR
»¼
»ÏecɽIc¾l ¼Able
f´g¾¿E
º·»47¼
ÀEMovÁºg Âà iÄLÅÆÇ/²1Èg geÉeÊatoË eÌECTËiÍAÎ ÏoBÐe
AÄd wѶ´ºÒ ha¶ÄesSÓ
AyD½.J 790¾¿DÀ
Back to Top
