TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 403 of 554

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

(16)

(17)

(18)

(19)

Install shaft (21 ) and position lever (17) so gap

adjusting screw (15) contacts low speed limiting

screw (22).

NOTE

Flat on shaft goes on flat in fork.

Place shaft (21 ) into spacer (23) and position

operating fork (24) with finished cam surfaces

of fork fingers facing rear of governor

housing.

Place tool between housing (2) and operating

fork (24) and press shaft (21) until spacer

(23)

does not move up or down.

Seat upper bearing (19).

(20)

Install upper bearing retaining screw (25),

lockwasher (26), and washer (27).

15-11