TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 116 of 736

TM 9-2815-225-34&P

0008 00

0008 00-26

BIG CAM III ENGINE REMOVAL (Contd)

82.

Remove starter S-terminal nut (15), lockwasher (16), and starter electrical harness lead no. 74

(17) from starter S-terminal (18). Discard lockwasher (16).

83.

Remove starter positive terminal nut (4), lockwasher (6), battery positive cable (5), and three

starter electrical harness leads no. 202 (7), no. 82 (8), and no. 421 (9) from starter positive

terminal (19). Discard lockwasher (6).

84.

Remove starter ground terminal nut (1), lockwasher (2), battery ground cable (22), ground jumper

cable (3), and starter electrical harness lead no. 83 (21) from starter ground terminal (20). Discard

lockwasher (2).

85.

Remove A/C electrical harness ground lead screw (13), two starwashers (11) and (12), A/C electrical

harness ground lead (10), and ground jumber cable (3) from engine (14). Discard starwashers (11).

86.

Remove fuel solenoid terminal nut (25), lockwasher (24), and fuel solenoid electrical harness

lead (26) from fuel solenoid (23). Discard lockwasher (24).

87.

Disconnect fuel pump pressure sensor electrical connector (28) from fuel pump pressure

sensor (27).

Figure 39. Starter Motor Electrical Connections Removal.

14

10

11

12

13

17

18

19

21

20

22

1

2

4

5

6

7

8

9

15

16

~

3

3